![]() |
![]() |
![]() |
![]() |
Category: Multirotors | ||
![]() ![]() |
|
![]() ![]() |
|
![]() ULTIMATE NAZE32 FEATURES > Too Many to fit here - Click the Link Enjoy !! Thanks - ImageBuff on fpvlab and rcgroups |
Created Size Downloads |
2015-05-01 7.87 MB 5209 |
||
![]() ![]() |
|
Configuration for Naza M Lite / V2 using SBUS. -Mode switch (GPS,ATTI,Manual) SE |
Created Size Downloads |
2015-06-09 77.03 KB 4582 |
||
![]() ![]() |
|
Used with OpenTX v 2.0.4 and CompanionTX 2.0.4. Should work with V2.0+ though. This will allow you to go into a "Stagility" mode where you can set the NanoQX on Agility mode and when the right stick is moved to +/-90% in either direction it will pop the NanoQX back into SAFE mode. See the instructions below. |
Created Size Downloads |
2014-06-25 76.03 KB 4335 |
||
![]() ![]() |
|
enjoy this splash screen on your Taranis... it's Rotor Riot and Flight Test combined :) |
Created Size Downloads |
2016-05-11 14.3 KB 4208 |
||
![]() ![]() |
|
My quadcopter setup file. Taranis transmitter with rotary switch, FC 3DR Pixhawk, 7 flight modes, - S2 pot replaced by 6 position rotary switch - S2: 6 flight modes - SA: OSD - SF: RTL - SD: Super Simple Mode - displaying flight mode on Taranis screen
|
Created Size Downloads |
2014-09-03 77.03 KB 4168 |
||
![]() ![]() |
|
![]() ![]() |
|
![]() ![]() |
|
Yet another quadcopter configuration for Taranis transmitter and 3DR Pixhawk FC.
Created |
2014-09-18 77.03 KB 3591 |
||
![]() ![]() |
|
Set up for the Blade 350 QX firmware 2.0 for use of all 4 flight modes |
Created Size Downloads |
2014-05-09 764.52 KB 3552 |
||
![]() ![]() |
|
![]() Made a cool Frsky taranis x9d start screen and I thought I would share
|
Created Size Downloads |
2016-02-12 6.87 KB 3517 |
||
![]() ![]() |
|
Model Setup for DJI Naza-m also tested on a DJI Phantom. |
Created Size Downloads |
2013-07-29 77.03 KB 3394 |
||
![]() ![]() |
|
S3 pot is 6 position rotary switch, must be calibrated. Amber sounds installed.
- displaying flight mode on Taranis screen |
Created Size Downloads |
2015-04-27 77.03 KB 3379 |
||
![]() ![]() |
|
![]() ![]() |
|
This is used on a AD1 quad. Taranis with x8r in D16 mode, 16 channels. Frsky lipo monitor. Have 3 rates and different expos on all three. 6 flight modes, RTL ch7 and Auto tune ch8. Led lights with steady and blinking by timer ch10. Amber sounds installed. Logical switches and special functions to call out flight modes, and battery info. |
Created Size Downloads |
2014-11-02 77.03 KB 3047 |
||
![]() ![]() |
|
![]() |
Created Size Downloads |
2015-02-22 77.03 KB 3033 |
||
![]() ![]() |
|
![]() ![]() |
|
Fully Functional - 5 Flight Modes, Smart, AP, Stability, Agility and RTH
Gimbal Control and Panoramic Mode
See Mirror File For Full Instructions |
Created Size Downloads |
2015-01-03 391.85 KB 2986 |
||
![]() ![]() |
|
Dromida Ominus |
Created Size Downloads |
2015-05-25 76.03 KB 2840 |
||
![]() ![]() |
|
Modified from the 350QX file from SLaSH, I'm just learning! I have physically swapped the switches SF & SH - used to TH on right - did not want momentary there. SB is flight modes, SC is rates. 8-25-14 Added some expo on all AIL, ELE & RUD Also added a "AAAAAHHHHH" Mode - If SH (TH for me) is up & SF (momentary for me) is down, overrides AIL, ELE & RUD to 0 and .... |
Created Size Downloads |
2014-08-25 76.03 KB 2802 |
||
![]() ![]() |
|
Adds " Stag-ility " mode to the Blade 350QX
|
Created Size Downloads |
2015-03-07 77.03 KB 2794 |
||
![]() ![]() |
|
Racing Quad template.
|
Created Size Downloads |
2017-08-24 76.01 KB 2783 |
||
![]() ![]() |
|
Thanks to Matt for finding these settings! http://blog.matthew-evans.info/2016/05/20/orangerx-the-fix/
I set SG as Acro/Stable-Mode switch. To toggle, pull it totally back and forward. SH is used to reset the timer.
|
Created Size Downloads |
2016-06-22 77.03 KB 2772 |
||
![]() ![]() |
|
![]() ![]() |
|
Basic setup for Naze32 - Aux1=SE, Aux2=SG
|
Created Size Downloads |
2013-12-23 76.03 KB 2738 |
||