![]() |
![]() |
![]() |
![]() |
Category: Multirotors | ||
![]() ![]() |
|
This is file for a 250 quad using a Thunder KK Pro flight controller and a Spektrum Satellite. Very basic with 2 flight modes. Good file to start with. Thanks, |
Created Size Downloads |
2014-10-17 77.03 KB 2412 |
||
![]() ![]() |
|
6 Pos switch for APM or alike |
Created Size Downloads |
2013-09-30 77.03 KB 2699 |
||
![]() ![]() |
|
This is a file that was given to me. It should be a nice starting place for setting your MR25 up! |
Created Size Downloads |
2016-07-31 500 B 1730 |
||
![]() ![]() |
|
S3 pot is 6 position rotary switch, must be calibrated. Amber sounds installed.
- displaying flight mode on Taranis screen |
Created Size Downloads |
2015-04-27 77.03 KB 3350 |
||
![]() ![]() |
|
![]() ![]() |
|
![]() ![]() |
|
Experimental first draft for the Durafly AutoG2 (NO MODEL HAS FLOWN WITH THIS) |
Created Size Downloads |
2015-01-22 77.03 KB 2237 |
||
![]() ![]() |
|
Modified from the 350QX file from SLaSH, I'm just learning! I have physically swapped the switches SF & SH - used to TH on right - did not want momentary there. SB is flight modes, SC is rates. 8-25-14 Added some expo on all AIL, ELE & RUD Also added a "AAAAAHHHHH" Mode - If SH (TH for me) is up & SF (momentary for me) is down, overrides AIL, ELE & RUD to 0 and .... |
Created Size Downloads |
2014-08-25 76.03 KB 2776 |
||
![]() ![]() |
|
Sticky Throttle, Proper throws to enable arming. |
Created Size Downloads |
2014-11-13 76.03 KB 2538 |
||
![]() ![]() |
|
Adds " Stag-ility " mode to the Blade 350QX
|
Created Size Downloads |
2015-03-07 77.03 KB 2769 |
||
![]() ![]() |
|
Fully Functional - 5 Flight Modes, Smart, AP, Stability, Agility and RTH
Gimbal Control and Panoramic Mode
See Mirror File For Full Instructions |
Created Size Downloads |
2015-01-03 391.85 KB 2959 |
||
![]() ![]() |
|
Blade 350qx backup file with fail safe and all 3 modes |
Created Size Downloads |
2014-03-20 32.14 KB 1984 |
||
![]() ![]() |
|
Simple setup, no dual rates or expo loaded yet. Module in radio was created from DX5e TX module in a Non Plus Taranis (I've got a real old one) |
Created Size Downloads |
2016-07-09 77.03 KB 2354 |
||
![]() ![]() |
|
Thanks to Matt for finding these settings! http://blog.matthew-evans.info/2016/05/20/orangerx-the-fix/
I set SG as Acro/Stable-Mode switch. To toggle, pull it totally back and forward. SH is used to reset the timer.
|
Created Size Downloads |
2016-06-22 77.03 KB 2742 |
||
![]() ![]() |
|
Used with OpenTX v 2.0.4 and CompanionTX 2.0.4. Should work with V2.0+ though. This will allow you to go into a "Stagility" mode where you can set the NanoQX on Agility mode and when the right stick is moved to +/-90% in either direction it will pop the NanoQX back into SAFE mode. See the instructions below. |
Created Size Downloads |
2014-06-25 76.03 KB 4299 |
||
![]() ![]() |
|
![]() Sticky Throttle Hold |
Created Size Downloads |
2014-01-03 77.03 KB 2573 |
||
![]() ![]() |
|
This is an example showing camera gimbal control with the aileron/elevator stick when SG is set to the middle position.
This has a basic MultiWii style throttle kill (zero throttle, left yaw) and will need to be adapted for other flight controllers or settings. |
Created Size Downloads |
2013-09-01 76.03 KB 2352 |
||
![]() ![]() |
|
![]() |
Created Size Downloads |
2015-02-22 77.03 KB 3003 |
||
![]() ![]() |
|
![]() ![]() |
|
Model Setup for DJI Naza-m also tested on a DJI Phantom. |
Created Size Downloads |
2013-07-29 77.03 KB 3366 |
||
![]() ![]() |
|
![]() ![]() |
|
![]() ![]() |
|
![]() ![]() |
|
Hubsan H107L X4 |
Created Size Downloads |
2016-11-24 77.03 KB 2303 |
||
![]() ![]() |
|
![]() MultiWii 6-channel setup with telemetry |
Created Size Downloads |
2013-08-27 76.03 KB 2660 |
||