Download

Was Change Sensor Id. Lua script to change Frsky sensor configuration from the radio (ported from erskyTx. Thanks to MikeB)

Download

SayAlt is a simple mix script to announce Altitude as the aircraft passes through the chosen altitude increments, either passing Up or Down.  It assumes the Taranis is using the FrSky Altimeter.  The script watches for the altitude transition and triggers a Logical Switch which then triggers a Special Function to make the voice announcement.

Download

This Mix script, called secursw.lua, creates an unKnockable safety like the one described by MattyB, a two position switch from a three position switch to be used where you want a control which cannot be inadvertantly activated by a bump.  It is a simple but interesting introduction to Lua script programming.

Download

Fully functional script using FrSky S.Port pasthrough from Pixhawk to Taranis XD9+:

A. Flight Mode, UAV battery voltage, TX battery voltage, timer1 info (mine counts from first thrust).

B. Ground speed in Km/h.

C. GPS altitude.

D. Messages received and severity. Up to 10 messages are recorded in a FIFO buffer. Number indicates order from 0, last message, to 10, ....

Download

This Telemetry Script measures the time Open TX takes to run through one cycle of its software.  You will note that running the script in Companion gives a different result than running the script in Taranis because the software is running in a processor with a different operating speed.

This is a useful practice script for learning how Lua scripts work but has no use in operating a ....

Download

Lua Telemetry Flight Status for Taranis/Horus/Jumper T16 transmitters using FrSky SmartPort(S.Port), D-series, F.Port & TBS Crossfire telemetry.  Compatible with INAV and Betaflight.

Download

A telemetry script to combine switches and inputs with custom names and a bitmap. Values can be represented in text or bars

Configuration with a text file for each model

Unzip the file content in your TELEMETRY folder

Inside the folder SrcMod place the config file and bmp for each model. Use same filename as the model name

See example of config file and adjust ....

Download

OpenLUA-plane - OpenTx 2.2 - Taranis X9d+

Download

This gives you up to 6 independent switches which can be toggled in sequence by 2 switches.